When buying any commercial equipment, it’s vital that you know the fundamental requirements as to what is needed to install the appliance. If maintenance problems are looked after or fixed immediately you’ll avoid future issues and ensure the equipment is running to its maximum functionality. Listed below is some basic advice to keep your commercial freezer in tip-top condition. The equipment is running to its maximum functionality. Listed below is some basic advice to keep your commercial freezer in tip-top condition.
Effects of moisture
If your freezer encounters too much moisture it can add to severe corrosion within the system. This can be as a result of the hydrochloric acid created when it reaches contact with water. Subsequently, a chemical reaction is formed by the combination of acid, copper and iron which produces a breakdown of valves, dryers and strainers. Moisture, dust and water are the most common causes of motor failure, so be aware of their possible effects.
Location of the equipment
Appropriate spacing should be left around the vital areas of the equipment so that inspection panels and service openings are exposed. Air cooling units should be placed in an area that allows for an unobstructed flow of air. If insufficient ventilation for air condensers is permitted, it can overload the motor and result in loss of energy. Similarly, space should also be made available for when you need to service valves or any other equipment, and this is applicable to all your appliances, such as commercial ovens, so they can be fixed. This is applicable to all your appliances, such as commercial ovens, so they can be fixed.
Refrigeration piping
When installing refrigerant lines, specific precautions must be followed and these include careful preparation of fittings and pipes, especially when cutting copper piping or tubes. Using a hacksaw to cut should be avoided at all costs, and so too should be the use of emery cloth, steel wool or sandpaper for cleansing in case it enters the system. So too should be the use of emery cloth, steel wool or sandpaper for cleansing in case it enters the system. If tubing has to be bent, specific tools for the job should be used and allow flexibility of lines to relieve the strain of joints in lines. If you have any doubts, contact your supplier such as https://www.247cateringsupplies.co.uk/ for expert advice.
Many maintenance problems usually originate from careless installation and poorly executed positioning and so it is vitally important to get it right first time to avoid being faced with problems later on. After installing your freezer, you must ensure that the entire circuit is properly sealed.
